Vu Solo2 Backup Image

My IPTV/Sky channels don't work on the backup. Solution: This is user-specific. You must use an FTP program (like FileZilla) to navigate to /etc/tuxbox/config/ and replace the oscam.server or CCcam.cfg file with your own personal subscription line. Should You Make Your Own Backup? Absolutely. Once you have installed the perfect vu solo2 backup image and tweaked it for your specific house (added your IPTV, set your motor position, fixed your EPG offset), you owe it to yourself to create a personal backup.

If you are a veteran, using a community backup image is a short-cut to testing new skins or plugin combinations without destroying your main setup (you can create a multiboot configuration). vu solo2 backup image

The image flashes, but gets stuck on "Loading defaults." Solution: The backup image was created for a different tuner configuration (e.g., DVB-T vs DVB-S2). Turn off the box, remove the USB, wait 30 seconds, and reboot. It should bypass the wizard. If not, re-flash a clean factory image first, then flash the backup. My IPTV/Sky channels don't work on the backup

Use the physical switch on the back of the unit. Do not just put it in standby. Should You Make Your Own Backup

If you have spent any time on satellite forums (like LinuxSat Support, OpenATV, or OpenPLi), you have undoubtedly seen the term . But what exactly is it? Why would you need one? And how do you install it without bricking your device?

Insert the USB into a rear port (front ports can be unreliable on older Solo2 units). Hold your finger on the "CH-" (Channel Down) button on the front panel of the receiver (not the remote). While holding CH-, flip the power switch on the back.

Look for an OpenATV 7.4 or 7.5 based Backup with OSCam r11718 or higher. Ensure the backup includes a "Swap Manager" setup (essential for heavy IPTV usage on the Solo2). Avoid any backup that is older than 6 months, as satellite frequency changes will render the channel list obsolete.