Datasheet - Hx8872-c

"HX8872-C application note timing parameters" or "Himax RGB to MIPI bridge design checklist". Disclaimer: All specifications mentioned are typical values based on industry reference designs. Himax Technologies reserves the right to change specifications without notice. Always validate with the latest official documentation.

// Soft reset to apply settings GPIO_Write(RESET_PIN, LOW); delay_ms(10); GPIO_Write(RESET_PIN, HIGH); delay_ms(120); // Wait for PLL lock Below is the typical connection diagram found in the hx8872-c datasheet for an SoC (like STM32, i.MX, or Allwinner) driving a MIPI DSI LCD. hx8872-c datasheet

If you are searching for the hx8872-c datasheet , you are likely working on a project involving a small-to-medium sized LCD panel (typically 480x854 to 720x1280 resolution) that requires a high-speed, low-power serial interface. This article consolidates the critical technical data typically found in the official datasheet, including electrical characteristics, pin configuration, timing diagrams, and reference design guidelines. "HX8872-C application note timing parameters" or "Himax RGB

I2C_Start(); I2C_Write(0x88); // Slave address + write bit I2C_Write(0x10); // PLL_CTRL0 register I2C_Write(0x2A); // Set PLL for 400 Mbps I2C_Stop(); I2C_Start(); I2C_Write(0x88); I2C_Write(0x14); // Lane control I2C_Write(0x03); // Enable 2 lanes I2C_Stop(); Always validate with the latest official documentation