Everstart 6811a Smart Charger Manual 2021 -
Disclaimer: This guide is for informational purposes. Always refer to the physical safety labels on your specific charger.
Since physical manuals are often lost or printed in tiny, unclear text, this article compiles all essential functions, safety protocols, troubleshooting steps, and charging modes based on the 2021 manufacturing specifications for this specific model. Model Number: 6811a Type: Fully Automatic, Microprocessor-Controlled Smart Charger Manufacturer: EverStart (Walmart Exclusive Brand) / Manufactured by Schumacher Electric Corporation Release Year: 2021 Revision everstart 6811a smart charger manual 2021
A: Yes. The manual allows "in-vehicle" charging. Connect negative clamp to the engine block, not the negative terminal. Disclaimer: This guide is for informational purposes
| Problem / Display | Likely Cause | Solution | | :--- | :--- | :--- | | No lights, charger dead | AC outlet dead or internal fuse blown | Test outlet. Check 10A fuse inside charger (requires opening case – void warranty? Return to store). | | (Red LED on) | Clamps are backwards | Swap red and black clamps immediately. | | Check Battery (Red LED) | Battery is below 3 volts or has a shorted cell | Battery is likely dead. Try desulfation mode (see below). | | 25% LED flashes for 24+ hours | Battery won't hold charge | Battery has high resistance. Replace battery. | | Charger clicks on/off repeatedly | Bad connection or extremely sulfated battery | Clean clamps. If still clicking, battery is unrecoverable. | | Display shows "F01" or "F02" | Internal temperature sensor fault | Unplug for 30 minutes. If persists, replace charger. | | Problem / Display | Likely Cause |
Press the MODE button until the correct battery type (Standard, AGM, Gel, Deep Cycle) is lit.
A: No. The 6811a is a charger , not a jump starter. It provides 6 amps max—insufficient for cranking. Do not attempt to start a car with this unit attached.
