Decastar 150e Manual [2025]

A: Enter the Technician Menu → Select r.St (Reset) → Choose FACt → Confirm. This erases all calibration and parameters.

A: Yes. Configure P.09 = 3 for print mode. Connect a serial thermal printer (e.g., EPSON TM series) and press the F key. Conclusion: Master Your Decastar 150e Hunting for the Decastar 150e manual is the first sign of a responsible operator. Whether you need to perform daily zeroing, deep-dive into parameter P.30 for batching control, or diagnose a persistent ERR31 , the manual—augmented by this guide—will save you hours of downtime and prevent costly weighing errors. decastar 150e manual

| Error | Meaning | Solution (from manual) | |-------|---------|------------------------| | | EEPROM failure | Replace mainboard. Attempt reset via r.St in Tech Menu. | | ERR03 | A/D converter not responding | Check power supply (minimum 12V DC). Check internal ribbon cable. | | ERR05 | Weight exceeds max + 9d | Remove load. Check for mechanical binding. | | ERR08 | Underload (negative overload) | Calibration zero lost. Perform C.IN again. Check load cell wiring (Excitation +/-). | | ERR31 | Calibration weight error | Applied weight < 1% of full scale. Use larger test weight. | | Lo BAT | Low battery (if backup option fitted) | Replace internal battery or connect mains. | A: Enter the Technician Menu → Select r

A: No. The Decastar 150e does not have a backlight; it uses high-brightness LEDs. Dimming usually indicates low voltage (check 12-24V DC supply). Configure P

A: Likely moisture ingress or a damaged load cell cable causing a short. Disconnect load cell and check resistance between signal + and signal - (should be between 200-400 ohms for typical cells).

When you invest in industrial weighing equipment, the documentation is just as critical as the hardware. For owners and operators of the Decastar 150e indicator (often part of a larger scale system, such as a bench scale or floor scale), the manual isn't just a booklet—it’s the key to accuracy, safety, and longevity.