Cs-2200 Icom Ic-2200h Programming Software

Do not double-click setup.exe yet. Right-click the file > Properties > Compatibility tab. Check "Run this program in compatibility mode for" and select Windows XP (Service Pack 3) . Also check "Run as Administrator."

Most USB cables use the Prolific PL-2303 or FTDI chipset. You will need to install these drivers before plugging in the cable. On Windows 10/11, you may need to disable driver signature enforcement or find legacy drivers, as the IC-2200H is an older rig. Step-by-Step Installation Guide (Windows 10/11) Installing the CS-2200 software on a modern OS can be tricky. The original software was designed for Windows 95, 98, and XP. Here is how to force it to work today. CS-2200 Icom IC-2200H Programming Software

USB programming cables. Many third-party manufacturers (e.g., BTECH, Valley Enterprises) produce USB-to-TTL cables designed for the IC-2200H. When buying one, ensure the listing explicitly says "For IC-2200H." Do not double-click setup

Turn off the IC-2200H. Plug the cable into the DATA port. Hold down the ‘V/Mhz’ button on the radio face. While holding it, turn on the radio power. The screen will go blank or show "CLONE." This places the radio in programming mode. Now click "Write" in the CS-2200 software. Manual Programming vs. CS-2200: A Head-to-Head | Feature | Manual (Front Panel) | CS-2200 Software | | :--- | :--- | :--- | | Time for 200 channels | 4+ hours | 15 minutes | | Alpha tags | Painful multi-click menu | Type directly | | Odd splits | Not supported | Fully supported | | Backup | Impossible | Save .icf file to PC | | Error rate | High (missed tones) | Zero (validated fields) | | Cost | $0 | ~$40 (if found) | Troubleshooting Common CS-2200 Errors Even with the right gear, you may hit a wall. Here are the three most common issues and fixes: Also check "Run as Administrator

Programming this radio manually via the front panel is possible, but it is tedious and time-consuming. For anyone managing more than a handful of frequencies or setting up a fleet of radios, the CS-2200 software is an absolute necessity. This article dives deep into everything you need to know about the software, from installation to advanced memory channel tricks. The CS-2200 (often referred to as CS-2200H) is the official legacy programming application developed by Icom Inc. Unlike generic third-party software, the CS-2200 is built specifically for the Icom IC-2200H’s firmware architecture. It allows a user to connect the radio to a Windows-based PC via a specialized programming cable (typically an OPC-478 or USB clone cable) to read, write, edit, and clone memory channels.

Since Icom has discontinued it, you will likely find the CS-2200 on user forums (QRZ.com, eHam), eBay CDs, or archive.org. The file is usually a ZIP containing setup.exe .

Open Device Manager on your PC. Find your USB serial cable. Note the COM port number (e.g., COM5). Open the CS-2200 software. Go to Settings > Communications Port and change it to match (e.g., COM5). Set speed to 9600 baud .