If you own an Android TV box, a development board (like the Odroid-N2), or a generic streaming stick powered by an Amlogic chipset (S905, S912, S922X, etc.), you have probably encountered the need to flash firmware, unbrick a device, or perform a low-level format. To communicate with your PC, you need one critical piece of software: the Amlogic USB Driver for Windows 10 (64-bit) .
A: Yes, but USB passthrough is unreliable. You must install the driver on the host OS, then assign the USB device to the VM. Expect lower success rates. amlogic usb driver windows 10 64 bit
The official Amlogic USB driver acts as a bridge between the (the software used to flash firmware) and the hardware. Without this specific driver, the USB Burning Tool will show a status of "Connect Fail" or remain stuck at 0%. If you own an Android TV box, a
Without this driver, your computer will not recognize the device when it is in "Burn Mode" or "Mask ROM Mode." Windows might show an error like “USB device not recognized” or label it as an “Unknown Device.” This guide will walk you through everything you need—from downloading safe drivers to troubleshooting installation failures on modern 64-bit versions of Windows 10 and Windows 11. Amlogic chipsets use a proprietary protocol called WorldCup Device or GX burning for USB communication. The standard drivers included with Windows 10 do not support this protocol. Consequently, when you connect your Amlogic device via a male-to-male USB cable (holding the reset button), the PC sees hardware but cannot assign a functional driver. You must install the driver on the host