Program Epson 1390 Resetter — Adjustment

This article is a deep dive into what this program is, why you need it, how to find a safe version, and a step-by-step guide to resetting your printer’s waste ink counter. The Epson Adjustment Program (often abbreviated as AdjProg ) is an official service utility developed by Seiko Epson Corporation. It is not intended for end-users. It is a diagnostic and maintenance tool designed for authorized Epson service centers.

If you own an Epson Stylus Photo 1390 (or its regional variants like the Epson Artisan 1430 or Epson Photo 1400), you have likely encountered a frustrating and sudden halt in your printing. One day, your printer is producing stunning borderless photos; the next, it is flashing a set of ominous lights (often the two red lights alternating or both on solid). The printer refuses to move, the paper won’t feed, and a message on your computer screen reads: “Parts inside your printer are at the end of their service life.” Adjustment Program Epson 1390 Resetter

Before you toss this wide-format masterpiece into the recycling bin, there is a solution. It does not require a screwdriver, new parts, or a visit to a repair shop. What you need is the . This article is a deep dive into what

By using this utility, you regain control of your hardware. You can turn a $500 "broken" printer back into a working production machine in under 60 seconds. It is a diagnostic and maintenance tool designed

However, due to the proprietary nature of Epson’s firmware, this program has found its way into the hands of advanced users. The specific module we care about is the How the Epson 1390 Waste Ink Counter Works Every Epson inkjet printer (including the 1390) performs routine cleaning cycles. It shoots ink through the nozzles to prevent clogs. That ink has to go somewhere—it drains into a spongy absorbent pad located at the bottom of the printer (the "waste ink tank").

The printer tracks how much ink has been flushed into this pad using an internal software counter. Once the printer believes the pad is full (usually after 5,000 to 15,000 cleanings or prints), it triggers a "Service Required" error. The printer locks down completely to prevent overflow that could leak onto your desk.